nixCraft
Eth1 up at 10mb?
This is a discussion on Eth1 up at 10mb? within the Linux hardware forums, part of the Linux Getting Started category; I cannot get eth1 to come up at 1000mb. It always reverts to 10mb. I've turned autoneg off and it ...
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
11-26-2007, 08:24 PM
|
|||
|
|||
Eth1 up at 10mb?
I cannot get eth1 to come up at 1000mb. It always reverts to 10mb. I've turned autoneg off and it loses communications with other servers.
I've checked the router port, the cables by plugging my laptop in and it always came up at 1000mb. I've tried: ethtool -s eth1 speed 1000 duplex full autoneg on - always reverts to 10mb/full ethtool -s eth1 speed 100 duplex full autoneg off - loses communication 
|
| Sponsored Links | ||
|
|
|
11-27-2007, 04:30 PM
|
||||
|
||||
|
First, speed 1000 REQUIRES autonegotiate, it appers that ethtool is not compatible with your card / nic. Have you tried mii-tool ?
|
|
11-29-2007, 03:19 PM
|
||||
|
||||
|
It can pe your NIC, have your tried to swap NIC? Can you tell me NIC name? You may need to pass special kernel / module parameter to Ethernet card driver
|
|
11-29-2007, 07:38 PM
|
|||
|
|||
|
I'm embarassed to say but it ended up being my own fault. When I verified the cable by plugging it into my laptop and making sure it came up at a gig.....I checked the wrong cable.
 Sorry for wasting your time and thanks for the help.
|
 |
| Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) |
|
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Routing/copying data from eth0 and send over eth1 and eth2 | theVOID | Networking, Firewalls and Security | 2 | 04-14-2008 05:02 PM |
| how to rename eth0 to eth1 | deltamails | Networking, Firewalls and Security | 1 | 09-24-2007 07:53 PM |
All times are GMT +5.5. The time now is 12:40 PM.
